Step 8
Line up the end of one rail (finished side out) with the
pre-drilled holes in the headboard (finished side with
wood button facing in toward rail). Insert a bolt through
each hole so that it screws into the barrel nut in the rail.
Using a Phillips head screwdriver tighten the bolt (the
use of a flat head screwdriver to hold the barrel nut in the
correct position is recommended).
Step 9
Place footboard end (wood button side in) at the foot of
the bed. Repeat step #8 to attach.
NOTE: Full and Queen size Only - Leave bolts a little
loose for step 10 and 11.
Twin size skip to step #12
3 of 6
X859/X860/X858070702
To Next Page
Loading...
