La Marzocco STRADA EE - Page 9

EN
9
1) Accessories
Check the package to make sure that the
following accessories are included:
• a number of 1-dose and 2-dose
portalters orresponding to the
number of groups;
• replacement 1-dose and 2-dose
lters (one of each);
• 1 tamper;
• 1 blind lter;
• cleaning detergent, for the groups;
• 3 stainless steel braided hoses for
water connecons;
• 1,5 mt of reinforced plasc tubing for
drainage;
• 1 hose clamp;
• 1 TEE Fing.
In order to proceed with installaon, it is
necessary that the following are available:
• Pipes carrying drinking water with a
3/8”G (BSP) end connecon; (3/8”
Compression for USA and Canada)
• Electrical Supply according to the
specicaon of the espresso machine
purchased:
• Single/Three phase 220VAC - 50/60
Hz electrical connecon with ground,
protected socket and approved
interlock switch
• Single phase 200VAC - 50/60 Hz
electrical connecon with ground,
protected socket and approved
interlock switch
• Three-phase, 380VAC - 50 Hz electrical
connecon with neutral + ground, near
the bench on which the machine is
installed and terminang in a suitable
protected vepole socket equipped
with an approved interlock switch
• Waste water drain system.
Note:
• The drinking water mains valve and
the circuit breakers for the electrical
system need to be located in the most
convenient posion for the operator to
access them easily and quickly.
• The machine should be placed on a at
counter and must be placed in sengs
with the following temperatures:
Minimum room temperature: 5°C/41°F
Maximum room temperature:
32°C/89°F
• If the machine has been temporarily
housed in sengs with a room
temperature of less than 0°C/32°F,
please contact a service technician
prior to use.
• Water pressure supply must be
between 2 and 6 bar.
2) Water test kit
In order to enable you to check if your water
supply is within the suggested ranges, La
Marzocco machines will be equipped with
two units of a quick water test kit (see
image below) including 6 test-strips and
instrucon cards.
The parameters that you can measure are
Total Hardness, Total Iron, Free Chlorine,
Total Chlorine, pH & Total Alkalinity,
Chlorides.
Ideally, you should perform a test on the
water BEFORE the water treatment system
and again AFTER the water system in order
WARNING
AT EACH INSTALLATION, THE MACHINE
SHOULD BE EQUIPPED WITH A NEW SET OF
TUBES FOR PLUMBING AND RELATED
GASKETS.