Labgear EM1000 - User Manual

EM1000 HD Encoder Modulator
1
TV
Power Supply
12VDC
HDMI Source
Earth
TV TV TV
Combine aerial
and new signal
at amplier or
loop-through
the EM1000
PVR
Games Console
DVD/Blu-ray Player
Smart TV Box
Sat. Receiver
EM1000
Distribution
Amplier
Aerial
Distribution Amplier
TYPICAL INSTALLATION
Introduction
The Labgear EM1000 converts the signal from your HDMI source into
a digital format that can be distributed around your TV system
and received on all of your DTT receivers, PVR’s and TVs.
It preserves the High Denition quality of the original
source up to 1080p and allows you to set up the new
signal so that every TV receives it on your choice of LCN
channel number. You can also give the new channel a
name that is visible when selected by any TV connected.
If desired more than one EM1000 can be connected
into your system giving a wider choice of HD channels for
entertainment, information or security applications.
.
Signal sources
Any HD signal source up to 1080p resolution that uses an
HDMI output can be converted and distributed via the EM1000 including:
Blu-ray players, satellite receivers, terrestrial receivers and PVR’s, cameras, PC’s etc.
Safety
• Always use the 12VDC power supply provided. Using a higher voltage will damage the unit
and invalidate the warranty
• Do not connect the device to the power if the power cord is damaged
• Do not connect the unit to the mains until all cables have been connected correctly
• Do not cut the power cord
• Do not cover the ventilation slots,
the recommended clearances and
other precautions given in these
instructions must be observed to
prevent overheating. In addition,
units should not be positioned where
they are likely to become covered by
curtains, fabric or insulating material.
The unit should not be left resting on
a carpet
• This appliance is not waterproof, it is
intended for indoor use only and must
not be positioned where they could
be exposed to dripping or splashing
water. Objects containing liquids
should not be placed on or near the
amplier
• To prevent re, make sure the unit
and attached cabling is installed
well away from naked ames
• If the unit has been stored in cold
conditions allow it to warm to room
temperature before connecting to the
mains.
• NOTE: Multi dwelling systems must
be earth bonded using a minimum
4mm copper cable in accordance
with the CAI Standard.

Summary

Introduction to EM1000

Signal Sources

Lists compatible HD signal sources up to 1080p resolution for the EM1000.

Safety Precautions

Essential safety measures for operating the EM1000, including power, ventilation, and environmental factors.

Mounting and Installation

Screen Indicators and Controls

Details the EM1000's LCD screen and the functions of its navigation and selection buttons.

Installing Multiple Units

Quick Set-Up Procedures

Set Output Channel;Frequency

Guides users through setting the output channel and frequency for the EM1000.

Give Signal a Name (Optional)

Allows users to assign a custom name to the new signal for easy identification.

Set Logical Channel Number (Optional)

Provides instructions for setting an optional Logical Channel Number (LCN) for TV remote control.

Adding Multiple Signals

Steps for ensuring multiple signals are recognised uniquely by TVs.

Change TS ID

Procedure to change the Transport Stream ID for unique signal identification.

Change Program Number

Procedure to change the program number for unique signal identification.

EM1000 Specifications

Modulator Section Details

Technical specifications for the DVB-T modulator, including constellation, bandwidth, and frequency range.

HDMI Encoder Specifications

Technical details of the HDMI encoder, covering video resolution, aspect ratios, and audio compression.

General Specifications

General information including power supply, operating temperature, dimensions, and weight of the EM1000.

Labgear EM1000 Specifications

General

Brand	Labgear
Model	EM1000
Category	Modulator
Language	English