H50/150 Smart – User Manual
12
Recommendation
Never place the unit in a location where excessive heat, moisture, or corrosive materials are
present.
The unit construction provides extra protection against the risk of electrical shock by grounding
appropriate metal parts. The extra protection may not function unless the power cord is
connected to a properly grounded socket. It is the user’s responsibility to assure that a proper
ground connection is provided.
Never connect the inlet or outlet fitting to your building water supply or any water pressure
source.
Never use flammable or corrosive fluids with this unit.
Do not use automotive antifreeze. Commercial antifreeze contains silicates that can damage
the pump seals. Use of automotive antifreeze will void the manufacturer’s warranty.
Transport the unit with care. Inclination angle must be less than 60 degrees otherwise the
refrigeration system could be damaged. Sudden jolts or drops can damage the refrigeration
system.
Pay attention to all warning labels and never remove them.
Never operate a damaged or leaking equipment.
Never operate the unit without the cooling fluid in the reservoir.
Always turn off the unit and disconnect the power cord from the power source before
performing any service or maintenance procedure or before moving the unit.
Never operate the equipment with a damaged power cord.
Performance of installation, operation or maintenance procedure other than those described in
this manual may result in a hazardous situation and may void the warranty.
Never use water (including distillated and deionized) in units installed in environments where
temperatures go down below 5°C. We recommend 1:1 mixture of water and glycol to avoid
liquid freezing.
To Next Page
Loading...
Need help?
General
