4big Quadra USB 3.0 User Manual 19
MANAGE RAID
MODIFY RAID MODE
Important info: Changing the RAID mode destroys data stored on the 4big. If you have saved data on the
drives, back up data before following these steps.
Make sure that the 4big is turned off but that its power supply is connected and that it's connected to a1.
computer via an interface cable.
Use the sharp end of the RAID selection tool (A) to press and hold down the select button (B).2.
Without releasing the select button, turn on the product.3.
Once the RAID mode LEDs (D) start blinking (takes five seconds), release the select button.4.
The LED for the current RAID mode (D) will blink. Using the RAID selection tool, press the select button (B) to5.
toggle between the four different modes.
Once the LED for the RAID mode you want is blinking, press the confirm button (C). RAID initialization will6.
begin and will take less than one minute.
Next you must format the volume before it will mount on your computer. For instructions, refer to Formatting7.
Instructions.
To Next Page
Loading...
Need help?
General
