Setting Up Your LaCie Big Disk
page 14
LaCie Big Disk User’s Manual
more information.
3.2.2.2. Mac OS 9.x
To use your new LaCie Big Disk, first install the necessary driver software.
Silverlining Pro Installation
1) Insert the LaCie Storage Utilities CD in your computer’s internal CD/DVD drive.
2) Open the CD icon and double-click on LaCie Installer.
3) The Silverlining Utilities screen appears. Click on Continue.
4) The About to Install screen appears. Read the following information and click on Continue.
5) The License Agreement screen appears. Click on Agree.
6) The Installation screen appears.
7) Check the Silverlining Pro and FireWire Support boxes.
8) Click on Install.
9) A message appears to confirm that the installation was successful.
10) Click on Restart to use your FireWire peripheral immediately.
Hardware Installation
1) After following the steps in 3.1. Connecting The Power Supply
, power on the drive by pressing the On/Off button on the
front of the drive.
2) Connect the 9-pin end of the FireWire bilingual cable into the FireWire 800 port on the back of the LaCie Big Disk.
3) Connect the 6-pin end of the FireWire bilingual cable into an available FireWire 400 port on your computer.
4) Your LaCie Big Disk will now be ready for use. You can then use the formatting and partitioning capabilities in Silverlining
Pro to configure your hard drive system. Please refer to the Silverlining Pro documentation on the LaCie Storage Utilities CD-
ROM for more information.
To Next Page
Loading...
