48
SOLVING PROBLEMS
Problems Raisons Solution
Machine does not work 1.- Power cord is not plugged
in well.
2.- Power button is off.
3.- Problem from the power
supply.
1.- Plug in, turn on the machine.
2.- Turn on the power switch.
3.- Check if the other Machines
work normally.
Water temperature does not
increase
1.- Set temperature below or
close to the water
temperature.
2.- Set heating time is too short.
1.- Check the setting.
2.- Prolong the heating time.
Water goes on heating after the
set temperature is reached.
1.- Program is wrong.
2.- Temperature sensor is invalid.
3.- The circulator does not rotate.
1.- Restart the power switch.
2.- Repaired by the specialist.
3.- Repaired by the specialist.
E1 appears on the display. 1.- Machine does not be put into
water.
2.- Water level is too low.
1.- Put the machine into water
and restart the power switch.
2.- Add water, make sure the
water level is between the
MIN and MAX line.
Machine plugs in and turns on, but
no display in the LCD.
1.- Power button is off.
2.- Machine is wrong.
1.- Turn on the power switch.
2.- Repaired by the specialist
The pump is noisy 1.- Dirt in the pump
2.- The main body is not
assembled correctly
1.- Clean the machine and the
pump as instructed in the
manual chapter Cleaning or
ask a specialist to clean them.
2.- Read the instructions in the
section on cleaning and
maintenance
To Next Page
Loading...