What to do if LAEGENDARY Toy car going on its own?
If your LAEGENDARY Toy car is moving without input or not responding correctly, avoid pressing any buttons on the remote control while pairing it with the car. This can cause the car to memorize unintended commands. To fix this, rebind the remote and car by turning them on within 3 seconds of each other. This will reset the commands and ensure the car responds properly.
How to fix steering not working properly on LAEGENDARY Toy?
If the steering on your LAEGENDARY Toy is not working correctly, try the following: 1. Replace the remote's batteries with new ones and fully charge the car battery. 2. Turn the transmitter off and then on, and pair again, ensuring you don't touch the throttle during pairing. 3. Clean the steering arm set and confirm the arm is connected to the car. 4. Check that the light on the transparent wire coming out of the car is a solid red. 5. Unplug the wires connecting the servo and the ESC, then pair the car with the transmitter again to check for defective parts. If it pairs, the servo might be the problem. Servo and remote controllers can be ordered through the LAEGENDARY website.
Why is my LAEGENDARY Toy battery/charger not working?
Here's how to troubleshoot your LAEGENDARY Toy battery and charger: * A solid red light on the charger indicates the charger is plugged in. * A blinking red light means the charger is defective. * A blinking green light means the battery is plugged in and charging. * A solid green light indicates the battery is fully charged. * A blinking green light after 3-4 hours of charging suggests the battery is defective. Try charging the battery with a second USB charger to identify which component is defective. Replacement batteries and chargers can be purchased through the LAEGENDARY website.
How to rebind the remote control with the LAEGENDARY Toy car?
To rebind the remote control with your LAEGENDARY Toy car, first turn on the remote control, and within 3 seconds, turn on the car as well. If the initial attempt is unsuccessful, repeat this action 2-3 times. If pairing continues to fail, the remote and/or the ESC may need to be replaced.
What to do if LAEGENDARY Toy wheels are not spinning properly?
If the wheels on your LAEGENDARY Toy are not spinning properly: 1. Tighten the locknut (Part Number SN-WJ02) that holds the wheels in place. 2. If all parts are intact, the differential may be broken and needs to be replaced.
Why is there stripping sound upon accelerating LAEGENDARY Toy?
If you hear a stripping sound when accelerating your LAEGENDARY Toy, follow these steps: 1. Inspect the car to ensure all parts are in place and no foreign objects are caught in it. Refer to the schematic in the User Manual to check the parts. 2. Check the front and rear differentials (Part Number SN-ZJ06) to see if they are functioning properly with both the axles and main drive shaft. Make sure that the gears of either the differential and/or main drive shaft (Part Number SN-ZJ05) are not stripped.
General| Brand | LAEGENDARY |
|---|---|
| Model | Sonic |
| Category | Toy |
| Language | English |
Warnings about potential injuries from thrown objects and the need for eye protection.
Critical warnings regarding battery charging, fire, explosion, and supervision of minors.
Detailed guidelines for safe battery charging, handling, and storage to prevent hazards.
Initial steps for preparing the RC truck for operation, including body removal.
Step-by-step guide on charging and installing the rechargeable battery pack.
Instructions for installing batteries into the remote control transmitter.
Overview of the transmitter controls and functions for operating the RC car.
Detailed explanation of specific transmitter switches like Power, Trim, and Dual Rate.
Addresses problems like scratched tops, steering issues, and reverse command failures.
Solutions for cars not responding correctly or failing to pair with the remote.
To Next Page
