RIGGING / SAILS
35
3
RIGGING / SAILS
n 3.2 Standing rigging
The LAGOON 46 has been adjusted by the preparer or the mast
manufacturer when first masting.
The cables stretch a little during the first sailings. Therefore it is
advisable to have the mast inspected and adjusted by a specialist.
Before you put out to sea, it is essential to make sure that the standing
rigging is in good condition: inspect the turnbuckles and check the
condition of the shrouds.
To hoist a crew member up to the top of the mast, use the topping lift.
Belay the crew member with a bowline on the bosun’s chair ring (do
not use snap shackle or shackle).
RECOMMENDATION
Any intervention on the standing rigging comes
within a specialist remit.
Description of the ropes length (m)
diametre
(mm)
Jib halyard 55 12
Jib sheet 40 x 2 12
Mainsail halyard 70 12
Mainsail topping lift 46 12
Mainsheet 34 14
Mainsail traveller adjustment 19 x 2 10
Reef 1 32 14
Reef 2 40 14
Reef 3 53 14
Spinnaker / Code 0 sheet (optional) 29 14
Spinnaker / Code 0 halyard (optional) 75 10
Adjusting the Line driver mainsail traveller 21,5 10
Mainsail outhaul 25 6
To Next Page
Loading...
