WATER SYSTEMS
63
6
WATER SYSTEMS
One of the switches next to the toilets makes possible a water intake
cycle and a water outlet cycle.
The second switch makes possible to carry out a rinse cycle.
Rinse the toilets with fresh water and regularly clean the filters.
Close the valves after each use.
For the use and maintenance of the electric toilets, please refer to their
instruction guide.
l
USE OF THE HOLDING TANKS
The tanks are accessed via the passageway floorboards.
Make sure the drain valve of the tank is closed in order to avoid any
inadvertent discharge (the valve is closed when the handle is perpen-
dicular to the hose).
Tank drainage:
- In an authorized area, open the drain valve.
- In a marina equipped with an organic waste suction system, fit the
suction hose into the tank through the deck filler.
- Start the pump of the suction system.
Regularly rinse the holding tank.
The tanks shall be emptied when the boat is berthed in negative tem-
peratures.
n 6.3 Black waters
The boat is fitted with manual toilets and a 120 L black water tank in
each floater as standard.
She may be fitted with optional electric toilets.
l
USE OF THE MANUAL TOILETS
- Open the water inlet and drain valves.
To empty the bowl:
- Set the control lever of the pump slantwise (FLUSH) and operate the
pump.
To dry the bowl:
- Set the lever back vertical (DRY) and operate the pump.
In order to avoid clogging the toilets, use absorbent paper only and
pump until the emptying hose is completly empty.
Regularly rinse the toilets with fresh water.
Close the valves after each use.
l
USE OF THE ELECTRIC TOILETS
The electric toilets are rinsed with sea water.
Electrical pumps, filters, and supply valves are located in different wet
rooms and under the floors of the passageways.
- Switch on the 12 V domestic circuit.
- Open the water inlet and drain valves.
WARNING
Use the suction systems in marinas to empty your
holding tank.
In order to respect environment, do not discharge
your holding tanks near the shore.
To Next Page
Loading...
