When there is not enough water in the tank to run
another cycle, the indicator light blinks and the
machine stops working.
Add water to the tank and then press the on/off
button which puts the unit in standby and turns
off the “lack of water” indicator light.
To restart the unit, press the on/off button again
and select the desired ice cube size.
MAKING ICE CUBES
STEP 1: PREPARATION OF THE UNIT
Always put the unit on a at, dry and uncluttered surface (leave a
clearance of 15 cm around your unit).
STEP 2: CLEANING OF THE TANK AND THE SYSTEM
The water tank and the system must be cleaned before use.
*
To clean the tank, ll it with water (see step 3) and then open the
drain plug to let the wastewater drain out (see step 9). Throw this
water out.
*
Then plug in your unit and ll the tank with clean water (see
step 3), press the ice cube size selection button for three seconds
to activate the function of automatic cleaning of the system.
Once the
5
cleaning cycles are nished, drain off this water through
the drain plug (see step 9). Throw this water out.
STEP 3: FILLING OF THE TANK
Remove the ice cube dish.
Fill the tank, making sure that you do not go beyond the maximum
level indicated by the line and the “MAX” marking.
N.B. You can accelerate the ice cube making process by using very
cold water.
Be sure to change the water once a day. If the unit is not
used for a long period of time, you must replace the water.
The tank’s capacity is 2.1L.
Put the ice cube dish back in place and close the cover..
STEP 4: PROGRAMMING
Press the On/Off button to start your unit.
Choose the ice cube size (small or large), by successively pressing
the ice cube size selection button. The default size is the largest size.
68
To Next Page
Loading...