TROUBLESHOOTING GUIDE
In the event of unintentional disconnection of the cord or if you press the on/off button during operation, small pieces of ice may form and become
stuck in the ice cube tray tilting device and jam it. If this happens, unplug your unit and remove the pieces of ice by pushing the ice cube tray tilting
device towards the rear of the ice cube making dish. Then restart the unit.
Always strictly follow the preparation process described in these instructions. By doing so, you will avoid most problems. If you encounter difculties,
here is a table that will help you to understand why and how to solve the problem.
Problem Cause Solution
The “lack of water” indicator light is on There is no water left
or
The pump is lled with air
Fill the water tank up to the MAX level
Press the on/off button to start making ice cubes.
The indicator lights do not go on. The unit is not correctly plugged in
or
The fuses are out
Make sure that the cord is correctly attached
and that your electrical socket has no problems.
Otherwise, contact the after-sale service department.
The ice cubes made are too large and stick to each
other
The water temperature is too low.
or
Ice cubes from the preceding cycle remained in the
ice cube making tray.
Select the smallest ice cube size.
Remove the ice cubes after putting the machine
in standby.
All of the indicator lights blink at the same time The ice cube making tray is jammed Remove the ice cubes after putting the machine
in standby.
70
To Next Page
Loading...