Laguna Tools MTST5S-0135 - Default Chapter; Table of Contents

Table of Contents

8. WIRING DIAGRAMS
1. INFORMATION P1
2. MACHINE INFORMATION P6
3. ASSMBLY & SET UP
3-1. Setup safety……………………………………….………………..……………………................
P8
3-2. Unpacking………………….……….…………………………………………………………………….
P9
3-3. Extension table…………………………….…………………………………………………………..
P10
3-4. Rip fence……………………………………………………………………………………………………
P11
3-5.Fitting or change saw blade & riving knife…..…………………………………………….
P13
3-6. Fitting or changing the scoring blade…………………………………………………………
P17
3-7. Saw blade guard……..…………………………………………………………………………………
P18
3-8. Accessories………………………………………….……………………………………………………
P19
3-9. Wiring & test run……………………………………….…...………………………………………..
P20
4. OPERATION
4-1. Control panel and hand wheel..……………………..………….……………………………..
P22
4-2. Scoring blade tilting and lifting………………………………………………………………….
P23
4-3. Rip fence cutting……………………………………………………………………………………….
P24
4-4. Miter gauge cutting…………………………….…………………………………....................
P25
5. MAINTENANCE
5-1. Cleaning and checking…………………………….………..……………………………………...
P26
5-2. Lubrication ……………………………………..……….……………………………………………….
P28
5-3. Replacing belt……………………………………………..……….……………………………………
P29
6. TOOLS LIST P31
7. TROUBLESHOOTING P32
9. PARTS LIST
ASSEM01- Machine body & table
ASSEM02- Control panel
ASSEM03- Power unit
ASSEM04- Saw blade angle device
ASSEM05- Saw blade rise & fall device
ASSEM06- Scoring device
ASSEM10- Rip fence
ASSEM12- Saw blade guard
ASSEM14- Accessories