Laing Innotech LTC 302

To Next Page

To Previous Page

Laing Innotech GmbH + Co. KG Althuette Germany Instruction LTC 11

- 2 -

Table of Content

The LTC table controller - 5 -

Application - 5 -

Whom is this document prepared for - 5 -

Precondition for the use of this document - 5 -

Do not install system before programming! - 5 -

Safety instructions - 5 -

For all Laing Table Controllers and all accessories (products) please note: - 6 -

For the operation of height adjustable tables please note: - 6 -

Design of the table controllers - 6 -

Specifications - 7 -

Environmental conditions - 7 -

Dimensions - 8 -

Controller without OptoSense - 8 -

Controller with OptoSense - 9 -

Options - 9 -

Delivery contents - 9 -

Installation of the controllers - 10 -

Controllers without OptoSense - 10 -

Controller with OptoSense - 10 -

Controller with GyroSense - 11 -

Installation control panels - 12 -

Rectangular control panels - 12 -

Round control panels - 12 -

Oval control panels - 12 -

Electrical connection - 13 -

Connectable Motors - 14 -

Pin assignment controller - 14 -

- 14 -

Pin assignment motor - 14 -

Connection of the motors - 15 -

Connection of the control panels and other control options - 15 -

Control panels with cable - 15 -

Two control panels - 15 -

Up to 11 control panels - 16 -

OptoSense - 16 -

Wireless control panel - 17 -

Connection: - 17 -

Mounting: - 17 -

Pairing of the control panel to the controller - 17 -

Battery change - 18 -

Mains connection - 18 -

Laing Innotech LTC 302 - Page 2