Laing Innotech LTC 302

To Next Page

To Previous Page

Instruction LTC 11 Laing Innotech GmbH + Co. KG Althuette Germany

- 3 -

Precondition start of operation of the controller - 19 -

Start of operation - 19 -

Current based collision detection - 19 -

GyroSense based collision detection - 20 -

Reference run - 20 -

Determine the stroke by the reference run - 21 -

Safety zone - 21 -

Safety Input - 21 -

Automatic motor recognition - 23 -

Control through control panels - 23 -

All Control panels - 23 -

Control panels with memory keys - 23 -

Control panels with height indication - 24 -

Configuration of the controller though the “LM” control panels (control panels without height

indication) - 24 -

Store memory positions with “LM” control panels - 24 -

User height limit adjustment by “LM” control panels - 25 -

Adjusting upper and lower limit - 25 -

Delete user height limits - 25 -

Change the sensitivity of the collision detection by “LM” control panels - 26 -

Initiate a reference run by “LM” - 26 -

Stroke limit adjustment by “LM” control panels - 26 -

Adjust upper and lower stroke limit - 26 -

Delete stroke limits - 27 -

Configuration of the controller though the “LD” control panels (with height indication) - 28 -

Operation of “LD” control panels with two buttons - 28 -

Store memory positions by the “LD” control panels - 28 -

Memory key handling by the “LD” control panels - 28 -

User height limit adjustment by the “LD” control panels - 29 -

Adjust upper and lower limit - 29 -

Delete user height limits - 29 -

Change the sensitivity of the collision detection by the “LD” control panels - 30 -

Initiate a reference run by the “LD” control panels - 30 -

Change height indication from centimeter to inch by the “LD” control panels - 30 -

Enter service menu by the “LD” control panel - 31 -

Rest user settings - 31 -

Stroke limitation adjustment by “LD” control panels - 32 -

Adjust stroke upper and lower limit - 32 -

Delete stroke limits - 33 -

Related product manuals