21
90024140rev00
15 • SELF-DIAGNOSIS AND FAULT IDENTIFICATION
MESSAGES
“ Er 6 ”
No gas. Check that the shutoff valve is open and that
there is gas coming from the main. If there is no supply
from the main, inform the gas company or agency. If there
is no problem with the main, contact a manufacturer
technician or authorized service agent.
“ no ign ”
Gas appliances are fitted with ignition devices
incorporating an automatic reset function. If operation is
not restored automatically after several attempts, display 5
and 6 will show the error code [ NO IGN ] shown
alongside. A beep warns the operator. Press key 16 to
switch back on. If the fault persists, contact a manufacturer
technician or authorized service agent.
Note: Burner shutdown is a safety condition. Therefore,
this situation is not a sign of the appliance malfunctioning.
If, after carefully carrying out these checks, the
appliance still does not function properly, call a
manufacturer technician or authorized service agent.
Note: When contacting manufacturer service technicians,
try to explain the fault in as much detail as possible,
referring all the information indicated on the identification
data plate (see page 3).
The main fault warning messages are:
WARNING FOR GAS MODELS
“ doP ”
It appears when the door is open and signals that the door
microswitch fails to close the contact. Check that the door
is properly closed. If the signal persists, call the technical
service.
To Next Page
Loading...
Need help?
General
