22
GLASSES POSITIONING
In order to obtain a successful dishwashing, it is
suitable to take care of the way dishes are
placed. It is suitable to place glasses, inside the
wire basket with the concave side towards the
bottom. Place mixed cutlery in a vertical position
into the suitable container minding not to cram
them and with hafts towards the bottom (see the
drawing).
REGENERATING
(for machines with Water softener)
If the glass washer is equipped with a Water
softener it is possible to regenerate the resins.
When this operation is needed, the “F” lamp blinks
slowly.
To perform the REGENERATION operation, lift the
overflow out of the tank and wait for this to be
completely empty.
( Attention: as far as machines with drain pump are
concerned, see the instructions in the specific
paragraph to unload the tank).
When the tank is empty and the overflow
disconnected, close the door.
Push the "B" button fot three seconds until the
"F" lamp is lighted. After twenty (20) minutes the
"F" lamp is OFF.
The regeneration of resins has been completed
automatically and the machine is ready to operate
again.
After 45 washing cycles, this signaling is implicit.
According to the water hardness, it is possibile to
modify the programming of the regeneration. See the
corresponding table in the installer section.
SALT CONTROL
When it is necessary to add salt in the container, the
“F” lamp blinks quickly.
This operation is programmed to be performed every
10 regeneration cycles.
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it. Clean the gasket and screw the plug.
After having added the salt into the container, perform
the REGENERATION operation by following the
instructions indicated in the previous paragraph.
Attention!
The lack of salt in the container damages the
machine because of limestone, besides a defective
washing of glasses and dishes.
These damages are not covered by the warranty.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and cups
you must add a surfactant on water (Brightener).
Your cleansing agent supplier will be able to
suggest the most suitable product. Your machine
is equipped with a rinse aid dispenser. Mean
concentration used is 0,15 g/lt.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3 Afterwards push button “P” for 3 seconds.
(the lamp "H" is lighted).
The discharge will stop automatically after 5
minutes. The control lamp will stop flashing.
Reinstall the flow over and shut the door.
(see also the paragraph “Daily maintenance” on
page 23)
To Next Page
Loading...
Need help?
General
