22
GLASSES POSITIONING
In order to obtain a successful dishwashing, it is
suitable to take care of the way dishes are
placed. It is suitable to place glasses, inside the
wire basket with the concave side towards the
bottom. Place mixed cutlery in a vertical position
into the suitable container minding not to cram
them and with hafts towards the bottom (see the
drawing).
SALT CONTROL
(for machines with Water softener)
If the glass-washer is equipped with a Water
softener the regeneration of resins is
automatic according to parameters fixed by the
producer.
According to the water hardness, it is possibile to
modify the programming of the regeneration.
See the corresponding table in the installer section.
When it is necessary to add salt in the container, the
green lamp "H" lights up.
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it. Clean the gasket and screw the plug.
Attention!
The lack of salt in the container damages the
machine because of limestone, besides a defective
washing of glasses and dishes.
These damages are not covered by the warranty.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and cups
you must add a surfactant on water (Brightener).
Your cleansing agent supplier will be able to
suggest the most suitable product. Your machine
is equipped with a rinse aid dispenser. Mean
concentration used is 0,15 g/lt.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3 Afterwards push button “P” for 3 seconds.
(the lamp "H" is lighted).
The discharge will stop automatically after 5
minutes. The control lamp will stop flashing.
Reinstall the flow over and shut the door.
(see also the paragraph “Daily maintenance” on
page 23)
DRAIN PUMP INSTRUCTION
(only for machines with Drain Pump and Water
softener)
The drain pump automatically starts up at
each cycle to discharge the exceeding water
coming from the rinsing cycle.
In order to completely discharge the tank it is
necessary to perform the following operations:
1. Switch the machine main switch "A" off;
2. Remove the overflow from the tank;
3. Soon afterwards press the drain pump
pushbutton "P" .
After the water has completely flowed down, press
the drain pump pushbutton "P" to switch the pump
off.
WARNING!
DO NOT FORGET THE PUSHBUTTON "P" ON
"ON" POSITION; THIS CAN CAUSE DAMAGES
TO THE PUMP.
To Next Page
Loading...
Need help?
General
