Setting of regeneration cycles
By default the regeneration is planned every 5 washing cycles.
However, it is possible to plan the Regeneration on the basis of water hardness.
To do so, see the following table.
Water hardness
35÷40°F 30÷35°F 25÷30°F 20÷25°F 15÷20°F
Model
Default setting
Number of
cycles per
regeneration
Number of
cycles per
regeneration
Number of
cycles per
regeneration
Number of
cycles per
regeneration
Glasswashers
5 10 15 20 25
When the number of cycles suitable for the water hardness of your system has been established, it is
possibile to configure the dip-switch on the electronic card placed in the control box.
We reproduce in succession also a comparative table about the different kinds of degrees in the main
countries.
Comparative table of the different kinds of degrees:
Degrees °f °T °I °USA meq/l ppmCaCO
3
French 1 0,56 0,7 0,58 0,2 10
German 1,79 1 1,25 1,05 0,36 17,85
English 1,43 0,8 1 0,84 0,29 14,3
USA 1,71 0,96 1,2 1 0,34 17,1
Follow the instructions to programme the electronic board.
REGENERATION SETTING PROGRAMMING
1 - With the machine stopped, check the position of the dip-switches on the electronic board and
memorise it;
1 2 3 4
CON ADDOLCITORE
AVEC ADOUCISSEUR
WITH WATER-SOFTENER
MIT REINIGUNGSAPPARAT
2 - Then set the dip-switch in accordance with the following table, according to the number of
washing cycles you wish to set to start the regeneration operation signaling;
To Next Page
Loading...
