LAMBORGHINI R3 EVO 100 - 0.2.4 Lifting instructions

0-13
INTRODUCTION
Precautions to observe at the end of disassembly/assembly operations
l
If you drained the coolant, screw down the drain cap and add new coolant up to the level. Start the engine and let the coolant
circulated in the cooling system and then top up.
l
When the hydraulic equipment has been disassembled, add oil up to the indicated level. Start the engine and let the oil circu-
late in the hydraulic circuits and then top up.
l
When the variable displacement pump is removed, connect the drain pipe and ll the casing using the cap provided for this
purpose.
l
After having reassembled the joint boxes, cylinder joints and driveshafts, grease completely.
0.2.4 - Lifting instructions
DANGER
Machine units with a weight over 25 kg or with large dimensions, must be supported or removed with a lifting device
and metal cables or polyester belts.
Metal cables - belts
l
Use cables or polyester belts suitable for the weight to lift, referring to the following tables:
Table 9
METAL CABLES (standard «S» or «Z» twisted type) POLYESTER BELTS (with slots - simple)
cable Ø mm Capacity (kg) Width (mm) Capacity (kg)
60° 90° 60° 90°
8 650 620 500 25 500 400 860 700
10 1000 1740 1420 50 1000 800 1730 1410
12 1450 2500 2050 62 1250 1000 2160 1760
14 2000 3460 2820 75 1400 1120 2420 1980
16 2,600 4500 3670 100 2000 1600 3460 2820
18 3300 5710 4660 150 2500 2000 4330 3530
The capacity is calculated with a safety coefcient.
l
The cables and belts must be connected to the lifting hook in the central part; hooking the cables towards the end may cause
the load to slide during lifting.
l
Never hang a heavy load from just one cable; always use two or more symmetrical cables.
DANGER
Suspension from just one cable can cause the load to rotate and cause the cable to come untwisted, or slide from the
winding position; these possibilities can cause serious accidents.
l
Do not lift a heavy load when the two ends of the cables form a wide suspension angle. The permitted load (kg) decreases
when the suspension angle increases; the table below, indicates the variation in permitted load (based on the suspension
angle), for two Ø 10 mm diameter cables each with a load capacity of 1000 kg.