IMPORTANT: If your cooker hood appears not to be operating correctly,
please refer to the checklist below before contacting the Customer
Service number.
My extractor will not start.
Check that the extractor hood is connected to the electricity supply
Check that the fan speed control is set correctly.
My extractor is not working effectively.
The fan speed is not set high enough
The grease filters are dirty and require cleaning.
The kitchen does not have adequate ventilation.
If the extractor is set up for recirculation mode, check that the carbon filters
do not need replacing.
If the extractor is set up for ducted-out mode, check that the ducting hose
and discharge outlet are not blocked.
My extractor has switched off during operation.
The safety cut-out device has been tripped.
Turn off the hob and then wait for the safety cut-out device to reset.
IMPORTANT: If you have installed your extractor too low, the safety cut-out
device will frequently trip. Your extractor may become damaged if the
safety cut-out device is tripped frequently.
IMPORTANT: If your appliance appears not to be operating correctly,
then you should disconnect it from your mains supply and then contact
Customer Care number on the rear page of this booklet
DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF.
Please note that if an engineer is asked to attend whilst the product is under
guarantee and finds that the problem is not the result of an appliance fault, then
you may be liable for the cost of t
he call out charge.
SomethingWrongwithyourExtractor"
14
To Next Page
Loading...
Need help?
General
