Why is my Lamona HJA8701 not pumping out water?
If your Lamona Washer/Dryer isn't pumping out water, check that the drain hose isn't kinked and the drain pump isn't blocked. Refer to section 6.4 for instructions on how to clean the drain pump.
Why is my Lamona HJA8701 Washer/Dryer not spinning?
The anti-imbalance safety device in your Lamona Washer/Dryer may have tripped because the laundry isn't evenly distributed in the drum. If the laundry is still wet after the cycle, rearrange it by hand and repeat the spin programme only.
Why is my Lamona HJA8701 laundry not dried?
If your laundry isn't drying in your Lamona Washer/Dryer, check that the water tap is turned on, the load of laundry isn't too large, the drying time is long enough, and you've selected an appropriate drying time.
Why does my Lamona HJA8701 vibrate so much during spins?
If your Lamona Washer/Dryer is vibrating excessively during spins, ensure the appliance is properly leveled, it's not too close to walls or kitchen units, and the transit screws have been removed.
Why is my Lamona Washer/Dryer laundry not properly spun?
If your laundry isn't spinning properly in your Lamona Washer/Dryer, it may be because large items are balled up and not evenly distributed within the drum. Always wash a mix of large and small items.
Why does my Lamona Washer/Dryer not start?
If your Lamona Washer/Dryer isn't starting, make sure the plug is properly connected to the socket, the door is securely closed, and the “Start/Pause” button has been pressed.
What to do if my Lamona Washer/Dryer is not filling with water?
If your Lamona Washer/Dryer isn't filling with water, ensure the plug is correctly connected to the socket, the door is securely closed, and the water tap is turned on. Also, check that the water intake hose filters aren't blocked and the hose isn't trapped or kinked.
What to do if water is on the floor near my Lamona HJA8701 Washer/Dryer?
If you find water on the floor near your Lamona Washer/Dryer, check that the water intake hose fittings aren't loose and that the end of the drain hose is correctly positioned.
Why are my Lamona HJA8701 washing results unsatisfactory?
Unsatisfactory washing results from your Lamona Washer/Dryer may be due to too little or unsuitable detergent, difficult stains not pre-treated, incorrect temperature settings, or an overloaded drum.
Why is there too much foam in my Lamona HJA8701?
Excessive foam in your Lamona Washer/Dryer could be due to using a detergent not recommended for automatic washing machines or using too much detergent. Ensure the detergent is suitable and the quantity used matches the manual's instructions.
Essential safety precautions for installation and initial use.
Crucial safety guidelines for appliance operation and potential hazards.
Guidelines for safe electrical connection of the appliance.
Guidance on placing and levelling the appliance correctly.
Instructions for connecting the appliance to the water source.
Steps for correctly connecting the appliance's drain hose.
Detailed instructions for safe electrical connection of the appliance.
Guidance on using detergent and additives correctly.
Steps to turn on and select a washing programme.
Instructions for using combined wash and dry cycles.
Checks to perform if the appliance fails to start.
Checks to perform if the appliance is not filling with water.
Checks to perform if water is not being pumped out.
Troubleshooting for spin cycle failures.
Checks to perform if laundry is not drying properly.
Factors affecting washing results and how to improve them.
Explanation of error codes shown on the appliance display.
Essential safety precautions for installation and initial use.
Crucial safety guidelines for appliance operation and potential hazards.
Guidelines for safe electrical connection of the appliance.
Guidance on placing and levelling the appliance correctly.
Instructions for connecting the appliance to the water source.
Steps for correctly connecting the appliance's drain hose.
Detailed instructions for safe electrical connection of the appliance.
Guidance on using detergent and additives correctly.
Steps to turn on and select a washing programme.
Instructions for using combined wash and dry cycles.
Checks to perform if the appliance fails to start.
Checks to perform if the appliance is not filling with water.
Checks to perform if water is not being pumped out.
Troubleshooting for spin cycle failures.
Checks to perform if laundry is not drying properly.
Factors affecting washing results and how to improve them.
Explanation of error codes shown on the appliance display.
This document describes a washer-dryer, model HJA8701, designed for domestic use. It provides comprehensive instructions for installation, operation, and maintenance, emphasizing safety and proper usage to ensure optimal performance and longevity of the appliance.
The HJA8701 is a versatile appliance capable of performing both washing and drying functions for clothes and fabrics suitable for machine washing. It offers various washing programs tailored to different fabric types and soil levels, along with drying programs that can be integrated with washing cycles or run independently. The appliance is equipped with a control panel featuring a program selector, buttons for spin speed, options, delay timer, and drying, as well as a display that shows settings, cycle status, and recommended load weight.
Washing:
Drying:
General| Colour | White |
|---|---|
| Spin Speed | 1400 rpm |
| Washing Capacity | 8 kg |
| Delay Start | Yes |
| Child Lock | Yes |
| Drum Material | Stainless Steel |
| Dimensions (H x W x D) | 850 x 600 x 590 mm |
To Next Page
