08_
LAMONA Appliances
Safety
Safety when working with
electricity
• Any work on electrical
equipment and systems
should only be carried out
by authorised or qualifi ed
persons.
• In case of any damage,
switch off the product and
disconnect it from the
mains. To do this, turn off at
the fuse box.
• The appliance must be
installed so that it can be
completely disconnected
from the mains easily after
installation by the isolation
switch.
• Do not bend or trap cable
against hot surfaces during
install.
• Make sure that fuse rating is
compatible with the product.
• Do not switch the oven off
at the mains isolation switch
immediately after cooking.
Cooling fan continues to
run for up to 20-30 minutes
(approx) even after the oven
control is turned off.
• Keep all ventilation slots
clear of obstructions, as this
may cause premature failure
of the oven element.
• Do not allow the oven to cool
with the door open. Even if
the appliances door is only
open a little, front panels
become damaged over time.
of adjacent units could
become damaged over time.
Safety and cleaning
• Do not use harsh
abrasive cleaners or sharp
metal scrapers to clean the
oven door since they can
scratch the surface, which
may result in the shattering
of the glass.
• WARNING: Ensure that
the appliance is switched off
before replacing the lamp
to avoid the possibility of an
electric shock.
• Do not use oven light
for household room
illumination.
• Do not use steam
cleaners for cleaning.
• The appliance must not
be installed behind a
decorative door.
i
To Next Page
