8
www.howdens.com
• Be careful not to damage any part of the coolant
system whilst awaiting disposal, eg.
- puncturing the coolant channels in the condenser.
- bending any pipework.
• Splashes of coolant can damage the eyes.
• The oil in the compressor can be fatal if swallowed
or inhaled.
Electrical connection
• The appliance is supplied with a power cable and
moulded plug ready for connection to a 230v AC 50
Hz supply.
• The fuse rating should be 13 A.
• This appliance must be earthed.
• This appliance must be connected to a suitable
switched socket which is always easily accessible.
• The electrical connection must comply with
current local and national safety regulations
(BS 7671 in the UK).
Please remember that the manufacturer shall not
be held liable if the information given in this manual is
not observed.
Before operating the larder fridge
• Remove all packaging material from the inside of
the appliance.
• Clean the interior and the accessories as
recommended, see cleaning and care section.
• You may hear various noises coming from the
cooling system and when the compressor starts.
This is normal.
• Set the temperature control to 2, (initially).
• Front edges of the larder fridge may feel warm, this
is quite normal. (Designed to avoid condensation.)
• Do not load the appliance immediately after
switching on. Wait a couple of hours until the
correct storage temperature is reached. We
recommend that you check the temperature with
an accurate thermometer.
Installation instructions
• The room where the appliance is installed must not
be smaller than 10 cubic metres.
• See detailed ‘Installation Instructions’, including
reversing door opening direction.
• This appliance has been designed to operate in
ambient temperatures up to 38°C (100°F). If the
ambient temperature is below 0°C, the food in
the larder fridge will freeze. We recommend you
don’t use the larder fridge in such low ambient
conditions.
• Do not place the appliance in direct sunlight as this
may cause the appliance to work less efficiently.
• WARNING: To avoid a hazard due to instability of
the appliance, it must be fixed in accordance with
the installation instructions.
Replacing the interior light
The LED lamp is not replaceable by the user.
If a failure occurs please call LAMONA Service Line.
• The plug and mains cable must not come into
contact with the back of the appliance. Vibrations
can damage them; which could result in a short
circuit.
• Do not connect the appliance to the mains
electricity by an extension lead or multi-adapter.
• The appliance must not be used with energy-
saving plug devices. The appliance will not function
correctly and may overheat.
• If the mains cable or plug needs to be replaced this
must be done by a suitably qualified person.
• During a power cut, unplug the appliance from the
mains socket. Following a power cut wait 5-10 mins
before connecting to the mains socket.
1 - Installation
To Next Page
Loading...
