13
3.Installation
Before Using Your Wine Cooler / Beverage Cooler
Remove the exterior and interior packing.
Before connecting the wine cooler / beverage cooler to the power source,
let it stand upright for approximately 12 hours. This will reduce the
possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water with a soft cloth.
The cooler is specially designed for wine storage, please do not put in
other goods.
The cooler should be placed independently so as to make sure good heat
dissipation. The back of the cooler should be away from the wall 10cm at
minimum.
Place your wine cooler / beverage cooler on a floor that is strong enough to
support it when it is fully loaded. To level your wine cooler, adjust the front
leveling leg at the bottom of the wine cooler.
Locate the wine cooler / beverage cooler away from direct sunlight and sources
of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.
Avoid locating the unit in moist areas.
Plug in the proper power socket. Make sure that the shape and voltage of the
socket is consistent with the nameplate on the back of the cooler.
To Next Page
Loading...
Need help?
General
