96-61836 • LANDA MVC • REV. 11/04
13
PRESSURE WASHER
OPERATOR’S MANUAL
MAINTENANCE & SERVICE
1. Remove the tank head assembly by unscrewing
the three Tek screws and lifting the tank head off.
2. Remove the two pipe nipples and associated fit-
tings.
3. Lift the coil out of the outer wrap.
CAUTION: The coil weighs about 80 lbs. Use proper
lifting techniques.
4. Clean, repair and replace the coil by reversing the
above steps.
Coil Reinstallation:
Reinstall by reversing the above steps 4 through 1.
Final Note:
The 12 VDC burner systems can draw as much as 18
amps! For such motors to run properly, the battery and
engine charging system must be kept in good condi-
tion, and the engine must run fast enough to adequately
charge the battery. Do not throttle down the engine for
any length of time.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
To Next Page
Loading...
