6
ZG SERIES PRESSURE WASHER OPERATOR’S MANUAL
LANDA ZG • REV. 5/02
Cleaning heavy dirt or material away with a hard stream
of clear water is recommended before using a cleaning
agent.
SHUT DOWN PROCEDURES
1. Rinse all lines (and injector) with clean water, to re-
move any soap residue.
2. Turn engine off.
3. Turn off water supply.
4. Open spray gun to relieve remaining pressure.
5. Remove water supply hose.
6. In freezing conditions, disconnect water supply and
open spray gun to allow water to drain, then turn off
motor.
CAUTION: Do not allow pump to run longer than 5
minutes without water. Disconnect all hoses to al-
low water to drain.
To Next Page
Loading...
