Landauer POCKET ANNEALER

To Next Page

LANDAUER 01 40 95 62 90 service@landauer.fr www.landauer.eu

POCKET ANNEALER

Instruction of use

Position the Pocket Annealer with the slot for the dosimeter on the top

as shown on the picture.

Connect the power supply.

Press the start button on the side of the device.

Wait for the warm up (less than 10 seconds),

START-UP

«Ready» indicates that the annealing can start.

Release the badge in the slot for the dosimeter. The insertion is automatic, do not push the dosimeter.

The display shows «Dosimeter» for an Inlight dosimeter (XA or GA) and «Dosimeter type 2» for a nanoDot.

The annealing starts automatically.

The display shows «Annealing» and the remaining time.

Once it is complete, «Annealing Ended» appears.

The dosimeter goes up automatically.

ANNEALING PROCESS

Electric

connection

Start button

Display screen

Slot

for the dosimeter

Positioning of a GA InLight dosimeter Positioning a nanoDot in its adapter

Pocket Annealer is designed to reset InLight® dosimeters (GA or XA types) and nanoDot®.

Need help?

Do you have a question about the Landauer POCKET ANNEALER and is the answer not in the manual?

Summary

Pocket Annealer Start-Up

Dosimeter Positioning

Illustrates correct placement of GA InLight and nanoDot dosimeters in the device.

Annealing Process

Setting the Annealing Time

Recommended Annealing Time

Specifies the recommended duration for annealing dosimeters based on dose levels.

Online Tutorial