- 7 -
1) Firstly take some hot melt glue to fix the
clear pvc tubes (one for rudder and two
for elevator) on the both side as shown.
2) Then insert elevator and rudder push
rods into the fixed pvc tubes. Please be
reminded the elevator push rods must
be passed through the main fuselage to
the rear part.
07
1）Put the provided strong foam double
tapes on the EDF set bay first.
08
1) Put on the EDF set on the bay and make
sure the EDF set on the right position
and alignment is correct.
2) Tight up the ESC and leading the related
power and control cords to the front of
the main fuselage compartment
09
To Next Page
Loading...
