What to do if my L&R Quantrex Q310 Cleaning Equipment cleaner will not start?
If your L&R Cleaning Equipment cleaner will not start, make sure it is plugged into a functioning electrical outlet. Also, turn the timer clockwise and ensure the rear power switch is ON. If the fuse is blown, call an authorized service center.
Why is there decreased ultrasonic activity in my L&R Quantrex Q310?
If your L&R Cleaning Equipment shows decreased ultrasonic activity, ensure the tank was filled with warm tap water plus cleaning solution and has run for 5 to 10 minutes to degas the solution. Also, change the solution if it's dirty. Adjust the solution level to one inch from the top of the tank with the load. Clean the tank with warm water and a non-abrasive cloth if the tank bottom is covered with soil particles. Don't use de-ionized water, as it does not cavitate as well as ultrasonic solutions.
Why is my L&R Quantrex Q310 operating but not heating the solution?
If your L&R Cleaning Equipment operates but does not heat the solution, first, ensure the heat switch is turned ON. If the issue persists, the heater may have malfunctioned, and you should call an authorized service center.
Steps to prevent electric shock when operating the cleaner.
Important guidelines and warnings for safe and effective use of the cleaner.
Steps for unpacking the cleaner and checking for shipping damage.
Instructions for placing and connecting table top ultrasonic cleaners.
Procedures for installing the ultrasonic cleaner tank into a countertop.
Instructions for connecting the ultrasonic cleaner tank to the generator unit.
Procedure for placing items directly into the cleaning solution.
Procedure for using auxiliary pans or beakers for cleaning.
General| Model | Quantrex Q310 |
|---|---|
| Category | Cleaning Equipment |
| Type | Ultrasonic Cleaner |
| Ultrasonic Frequency | 40 kHz |
| Heater | Yes |
| Timer | 1-30 minutes |
| Power Supply | 110-120V, 60Hz |
To Next Page
