Laney CUB 12 User Manual

Page
11/ 16
12
10
11
12
15
13
14
11
15
uses the amplifier in full power mode.
<1W INPUT: Plugging in to this input switches the output power stage down to around 1W. (Use this feature for
recording or bedroom playing).
(Always switch off and disconnect the power cord when
not in use).
SERIAL NO: Displays the model details and serial number of the unit
EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mismatched impedance will
reduce the amplifiers performance and in some cases may cause damage to your amplifier. Try your CUB12 into a Laney
extension cabinet - you will be amazed.
MAINS LEAD: The mains lead is permanently attached so
that it does not get lost or forgotten when you transport your
amp. Stow it in the straps provided when not in use to avoid
damage.
EFFECTS LOOP: SEND/LINE OUT: Connect the input
of your external effect to this socket. This is an insert type
control, therefore all of the signal leaves the amplifier via the
`Send’ socket to be processed. This socket can also be used as a
Line Level Out. (-10dBV Nominal)
EFFECTS LOOP: RETURN: Connect the output from
your external effects to this socket. The effects loop allows you
to connect external effects such as tremolo, chorus and delay
to your amplifier. (-10dBV Nominal)
HANDLE: Laney soft grip handle for comfortable
transportation.
CUB
2
Laney
LZB1234
13
10
14
MAXIMUM POWER CONSUMPTION
50 WATTS 50/60Hz
SUPPLY VOLTAGE:

Laney CUB 12 Specifications

General

Output Valves	2 x EL84
Outputs	External speaker socket
Reverb	Yes
Effects Loop	Yes
Footswitch	FS1 (not included)
Power	15 watts
Channels	1
Controls	Gain, Treble, Middle, Bass, Volume, Tone, Reverb
Preamp Valves	3 x ECC83