Laney LC30-II User Manual

10
MODEL LC30-II/LC50-II
9
1
2
3
4
11
HI INPUT: This input provides maximum gain from the instrument to the pre amp. is extremely useful for
guitars with single coiled or low gain humbucker type pickups. Use of high gain pickups in this input
may drive the preamp too severely, causing a "mushy" output
LO INPUT: This input is attenuated down approximately 6dB from the Hi input. It is useful in obtaining
output that is "tight" not "mushy" from high end gain humbucker type pickups.
VOLUME: Sets the overall listening level of the clean channel.
BRIGHT SWITCH: Adds brightness and sparkle to the upper frequencies of the amplifier. These upper
frequencies are more noticeable at low gain settings.
BASS: Controls the low frequency EQ in the preamplifier.
MIDDLE: Controls the mid frequency EQ in the preamplifier.
TREBLE: Controls the high frequency EQ in the preamplifier.
CHANNEL SWITCH: Allows switching from 'Clean' to 'Overdrive ' channels without a footswitch
DRIVE: Controls the level of valve 'Overdrive'
MASTER VOLUME: Controls the overall listening level of the 'Overdrive' channel.
REVERB: Controls the overall reverb level for the amplifier.
EFFECTS: Controls the level of signal sent to the effects loop send socket.
3 4
5
6
1
7
11
VOLUME BASS MIDDLE TREBLE BRIGHT BASS MIDDLE TREBLE DRIVE MASTER
VOLUME
CHANNEL REVERB EFFECTS
LO
HI
STANDBY POWER
12
8
9
10
17
14
15
16
18
19
13
20
CABINETCABINET
MODEL LC30MODEL LC30
THIS APPARATUS MUST BE EARTHEDTHIS APPARATUS MUST BE EARTHED
WARNINGWARNING
VOLTAGEVOLTAGE
SUPPLYSUPPLY
POWER FUSEPOWER FUSE
HT FUSE
MADE IN U.K. BY BLT INDUSTRIES LTD.MADE IN U.K. BY BLT INDUSTRIES LTD.
SERIAL NO.SERIAL NO.
THIS APPLIANCE TO RAIN OR MOISTURE.THIS APPLIANCE TO RAIN OR MOISTURE.
ELECTRIC SHOCK DO NOT EXPOSEELECTRIC SHOCK DO NOT EXPOSE
TO REDUCE THE RISK OF FIRE ORTO REDUCE THE RISK OF FIRE OR
WARNINGWARNING
SERVICE PERSONNEL.SERVICE PERSONNEL.
REFER SERVICING TO QUALIFIEDREFER SERVICING TO QUALIFIED
NO USER SERVIABLE PARTS INSIDE.NO USER SERVIABLE PARTS INSIDE.
SHOCK DO NOT REMOVE COVER.SHOCK DO NOT REMOVE COVER.
TO REDUCE THE RISK OF ELECTRICTO REDUCE THE RISK OF ELECTRIC
CAUTIONCAUTION
RATING.RATING.
T250mAT250mA
WITH SAME TYPE ANDWITH SAME TYPE AND
OF FIRE REPLACE ONLYOF FIRE REPLACE ONLY
TO REDUCE THE RISK TO REDUCE THE RISK
CAUTIONCAUTION
MAXIMUM POWER CONSUMPTION
INTERNALINTERNAL
CABINETCABINET
4 OHM4 OHM
8 OHM8 OHM
EXTENSIONEXTENSION
RETURNRETURN
EFFECTS LOOPEFFECTS LOOP
SENDSEND
FOOTSWITCHFOOTSWITCH
REVERBREVERB
DRIVEDRIVE
TipTip
RingRing
Part No:- 8P-8532Part No:- 8P-8532
~~
250 WATTS 50-60 Hz250 WATTS 50-60 Hz
~~
~~
100V - 120V:-T5A100V - 120V:-T5A
220V - 240V:-T2A220V - 240V:-T2A
~
5
6
7
8
2
Laney
3
EXPLANATION OF TERMS

Laney LC30-II Specifications

General

Brand	Laney
Model	LC30-II
Category	Amplifier
Language	English