Need help?Do you have a question about the Laney RICHTER RBW100 and is the answer not in the manual?
General| Power Output | 100 Watts |
|---|---|
| Speaker Size | 1x12" |
| Effects Loop | Yes |
| Compressor | Yes |
| Channels | 1 |
| EQ | Bass, Treble |
| Outputs | DI |
Instructions and safety precautions before powering on the amplifier, including earthing and plug wiring.
Active and Passive/Active inputs for connecting bass guitars. Active basses use ACTIVE, non-active use PASSIVE.
Sets preamp gain level. Higher gain can cause clipping/distortion; use with VOLUME for desired sound.
Engages the on-board compressor to compress the input signal for a punchier sound.
Adjusts the low-frequency response of the pre-amplifier.
Selects MID-frequencies to cut or boost, used with Paramid Gain control.
Adjusts boost or cut level for the frequency set by control 5.
Controls the high-frequency response of the pre-amplifier.
Sets the overall listening level of the amplifier.
XLR socket for direct-injection to mixing-desk or power-amplifier, providing a low-impedance output.
Headphone output socket for silent practicing.
Send and return sockets for connecting external effects-units.
Socket for connecting an external tuner.
Switches the on-board horns either on or off.
Increases low-end definition for a tighter, punchier sound by dipping frequencies around 200Hz.
Controls the high-frequency signal content of the pre-amplifier, typically set at 3K.
Allows the on-board limiter to be defeated by pulling the switch.
Connects an extension cabinet. Minimum impedance must be 8 Ohms to avoid overheating.
Provides a line-level signal source for connecting to an additional external power-amplifier.
Factory-determined EQ settings for building individual tone, boosting high-end (HI) or low-end (LO).
6-band EQ for extensive tonal shaping, allowing cuts or boosts to frequency bands.
Controls for pronounced bottom-end (FULL), increased attack (BRIGHT), and horn engagement (HORNS).
Warnings regarding dangerous voltage, risk of electric shock, and not removing covers.
Warning to prevent electrical shock or fire hazard by not exposing the appliance to rain or moisture.
Guidance on mains lead colour coding for earth, neutral, live, and appropriate fuse fitting.
Information on electromagnetic fields emitted/affected by loudspeakers and guitar pickups.
To Next Page
