Display settings
Parameter settings
After power-on, Press and hold the mode button for 3 seconds will
enter the instrument parameter setting interface.
First of all, we can see P01 , and then press Mode button by turns, we
can find P01, P02, P03, P04, P05, P06, P07, P08, P09, P10, P11, P12,
P99, 0d0.
P01: KPH/MPH selection setting
At P01, pressing gear button by turns, we can see KM/h and MPH.
Double-click the power button to confirm KM/h or MPH. The default is
KM/h.
P02: Voltage setting
The standard Voltage setting of P02 should be 60 for LANGFEITE C5
E-scooter.
P03: Wheel diameter setting
At P03, pressing button by turns. The wheel diameter range is
"5-50", The standard wheel diameter of P03 should be "10" for
LANGFEITE C5 electric scooter. Therefore, please don't change this
setting.
P04: Pole Pairs of Motor
This P04 setting has been programmed by the controllers. The
standard pole pairs of motor should be "30" for the LANGFEITE C5
electric scooter. Therefore, please don't change this setting.
To Next Page
Loading...
