P10: Soft start and hard start selection settings
This P10 setting has been programmed by the controllers. The
default setting is "3". Therefore, please don't change this setting.
P11: EBS brake strength adjustment
This P11 setting has been programmed by the controllers, The
default setting is "3". Therefore, please don't change this setting.
P12: Release the speed limit
At P12, Please enter password “0105”.
After entering the correct password,we can see the range is "0"—"1",
"0" means no speed limited. "1" means speed limited. The default
setting is "1". When switching numbers "1" to "0", wait 8 seconds. It will
automatically release the speed limited.
P99: Restore factory settings
Press with 3-5 seconds, Wait for "99" to become" - -", means the
factory setting is completed.
The system will automatically return to
cycling mode.
odo : Reset the total mileage
At odo, Press and hold the button with 5 seconds, reset the total
mileage task is completed. The system will automatically return to cycling
mode.
To Next Page
Loading...
