Lantronix EDS-MD Series - Page 133

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 133
modem control disable
Does not watch the modem control pin to
disconnect.
modem control enable
Watches the modem control pin and disconnects if it
is not asserted.
no stop character
Removes the stop character.
no timeout
Disables disconnect after timeout feature for
tunneling sessions.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
stop character <control>
Sets the stop character. The character may be input
as text, control, decimal, or hex. A control character
has the form <control>C. A decimal value character
has the form \99. A hex value character has the
form 0xFF.
timeout <milliseconds>
Disconnects when no data has been received on
the line (serial port) for the specified length of time.
<milliseconds> = timeout in milliseconds.
write
Stores the current configuration in permanent
memory.
disconnect (tunnel-disconnect:10) level commands
clrscrn
Clears the screen.
exit
Returns to the tunnel level.
flush serial disable
Does not flush serial data upon closing a tunneling
connection.
flush serial enable
Flushes serial data buffer when a tunneling
connection is closed.
flush stop character disable
Forwards the stop character from the Line to the
network.
flush stop character enable
Prevents the stop character from the Line from
being forwarded to the network.
modem control disable
Does not watch the modem control pin to
disconnect.
modem control enable
Watches the modem control pin and disconnects if it
is not asserted.
no stop character
Removes the stop character.
no timeout
Disables disconnect after timeout feature for
tunneling sessions.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
stop character <control>
Sets the stop character. The character may be input
as text, control, decimal, or hex. A control character
has the form <control>C. A decimal value character
has the form \99. A hex value character has the
form 0xFF.
timeout <milliseconds>
Disconnects when no data has been received on
the line (serial port) for the specified length of time.
<milliseconds> = timeout in milliseconds.
write
Stores the current configuration in permanent
memory.