Lantronix SGX 5150 Command Reference

3: Command Line Interface
SGX 5150 IoT Device Gateway Command Reference 14
TM
Commands at the login level (see Figure 3-2 Login Level Commands below) do not affect current
configuration settings and are not displayed initially. If you type ?, you will see the login
subcommands. These commands provide diagnostic and status information only.
Figure 3-2 Login Level Commands
admin@SGX5150-0080a3b028b6>?
clrscrn exit
iperf <params> ping <host>
ping <host> <count> ping <host> <count> <timeout>
ping6 <host> ping6 <host> <count>
ping6 <host> <count> <timeout> show
show history show multicast routes
show routes show rules
tcpdump <parameters> trace route <host>
trace route <host> <protocol> enable
admin@SGX5150-0080a3b028b6>
Note: To configure the SGX 5150 IoT device gateway, you must be in the enable level
and any of its sub-levels. Figure 3-3 Enable Level Commands below shows the enable
level commands.
Figure 3-3 Enable Level Commands
admin@SGX5150-0080a3b028b6(enable)#
admin@SGX5150-0080a3b028b6(enable)#?
auto show interfaces auto show processes
clrscrn configure
connect connect line <line>
device disable
dns email <number>
exit filesystem
iperf <params> kill ssh <session>
kill telnet <session> line <line>
ping <host> ping <host> <count>
ping <host> <count> <timeout> ping6 <host>
ping6 <host> <count> ping6 <host> <count> <timeout>
reload reload factory defaults
show show history
show interfaces show ip sockets
show multicast routes show processes
show routes show rules
show sessions ssh
ssh <optClientUsername> <host> ssh <optClientUsername> <host> <po
ssl tcpdump <parameters>
telnet <host> telnet <host> <port>
trace route <host> trace route <host> <protocol>
tunnel <line> usb <line>
write xml
admin@SGX5150-0080a3b028b6(enable)#
See the Chapter 5: Commands and Levels at the end of this document for a complete list of levels,
commands, and descriptions.

Lantronix SGX 5150 Specifications

General

Certification	FCC ICES-003:2012 RED 2014/53/EU, EMCD 2014/30/EU, EN 300 328 V1.9.1, EN 301 489-1 V1.9.2, EN301 489-17 V2.2.1, EN 301 893 V1.8.1, EN 62311: 2008 AS/NZS CISPR 22, AS/NZS 4268: A1: 2013, AS/NZS 2772.2VCCI EN 55022:2010, EN 55024:2010, EN 61000-3-2:A2 2009, EN 61000-3-3: 2008 UL 60950/CSA 22.2 No. 60950, IEC 60950 CE LVD 2014/35/EU
LED indicators	Yes
Power requirements	9 - 30 VDC
Power over Ethernet (PoE)	No
Power consumption (typical)	1.9 W
Storage temperature (T-T)	-40 - 85 °C
Operating temperature (T-T)	-40 - 70 °C
Operating relative humidity (H-H)	5 - 95 %
Security algorithms	802.1x RADIUS, AES, EAP-FAST, EAP-PEAP, EAP-TLS, EAP-TTLS, FIPS 140-2, MSCHAPv2, TKIP, WPA, WPA2, WPA2-PSK, WPS
Authentication method	RADIUS
Ethernet LAN (RJ-45) ports	1
Supported protocols	IPv4/IPv6, TCP, UDP, ICMP, ARP, Auto-IP, DNS, (S)FTP
Frequency band	2.4 / 5 GHz
Cabling technology	10/100BASE-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11d, IEEE 802.11g, IEEE 802.11h, IEEE 802.11i, IEEE 802.11n, IEEE 802.1x, IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.3u
Ethernet LAN data rates	10, 100 Mbit/s

Weight and Dimensions

Weight	350 g
Dimensions (WxDxH)	110 x 89 x 26 mm