Lantronix SGX 5150 - Page 56

5: Commands and Levels
SGX™ 5150 IoT Device Gateway Command Reference 56
5: Commands and Levels
Click the level in the tree structure and it will take you to the command list for that level.
root
• enable (enable)
• bluetooth serial 1 (bluetooth-line-1)
• configure (config)
• access point (config-access-point)
• action (config-action-select)
• eth0 link state change (config-action:eth0 link state change)
• email (config-action-email:eth0 link state change)
• ftp put (config-action-ftp_put:eth0 link state change)
• connection 1 (config-action-ftp_put-
connection:eth0 link state change:1)
• connection 2 (config-action-ftp_put-
connection:eth0 link state change:2)
• http post (config-action-http_post:eth0 link state change)
• connection 1 (config-action-http_post-
connection:eth0 link state change:1)
• connection 2 (config-action-http_post-
connection:eth0 link state change:2)
• snmp trap (config-action-snmp_trap:eth0 link state
change)
• on scheduled reboot (config-action:on scheduled reboot)
• email (config-action-email:on scheduled reboot)
• ftp put (config-action-ftp_put:on scheduled reboot)
• connection 1 (config-action-ftp_put-
connection:on scheduled reboot:1)
• connection 2 (config-action-ftp_put-
connection:on scheduled reboot:2)
• http post (config-action-http_post:on scheduled reboot)
• connection 1 (config-action-http_post-
connection:on scheduled reboot:1)
• connection 2 (config-action-http_post-
connection:on scheduled reboot:2)
• snmp trap (config-action-snmp_trap:on scheduled re-
boot)
• usb0 link state change (config-action:usb0 link state change)
• email (config-action-email:usb0 link state change)
• ftp put (config-action-ftp_put:usb0 link state change)
• connection 1 (config-action-ftp_put-
connection:usb0 link state change:1)
• connection 2 (config-action-ftp_put-
connection:usb0 link state change:2)
• http post (config-action-http_post:usb0 link state change)
• connection 1 (config-action-http_post-
connection:usb0 link state change:1)
• connection 2 (config-action-http_post-
connection:usb0 link state change:2)
• snmp trap (config-action-snmp_trap:usb0 link state
change)
• wlan0 link state change (config-action:wlan0 link state change)