Button Signal
J7
Module
pin
Button Function
200 module to factory defaults
SW3 WAKE 20
Module Wake Up
Button assertion will wake up the xPico 200 module
from standby or sleep states. Requires the function
to be enabled on the module. See the xPico 200
Series Embedded Wi-Fi Gateway User Guide for
more information on low power states.
Additional Information
IntellectualProperty
Lantronix and xPico are registered trademarks of Lantronix, Inc. in the United States and
other countries.
Patented: http://patents.lantronix.com; additional patents pending.
Warranty
For details on the Lantronix warranty policy, please go to our Web site at
https://www.lantronix.com/support/warranty.
Disclaimer
This product has been designed to comply with the limits for a Class B digital device
pursuant to Part 15 of FCC and EN55032 Rules when properly enclosed and grounded.
These limits are designed to provide reasonable protection against radio interference in
a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with this guide, may cause
interference to radio communications. Changes or modifications to this device not
explicitly approved by Lantronix will void the user's authority to operate this device. The
To Next Page
Loading...
