Larius Giotto - User Manual

Questions and Answers

K
Katherine BatesAug 9, 2025
Why Larius Water Pump equipment does not start?
- S
  Sherri JacksonAug 9, 2025
  If your Larius Water Pump equipment isn't starting, check the following: ensure it's correctly connected to the power supply, inspect the extension cable, make sure the On/Off switch is in the “on” position and the pressure control knob is turned clockwise. Also, verify and replace the fuse if necessary. Try opening the drain valve to release pressure in the circuit. If none of these steps work, open the drain valve to release pressure and stop the machine, then disassemble and clean the pumping group and pressure transmitter.
C
christopher14Aug 15, 2025
What to do if Larius Giotto Water Pump equipment sucks but does not reach the pressure desired?
- A
  adriennestevensAug 15, 2025
  If your Larius Water Pump equipment sucks but doesn't reach the desired pressure, try the following: add more product, check the suction pipe, close the recirculating-safety valve, replace the gaskets, and disassemble the pumping group.
T
Tina GeorgeAug 19, 2025
What to do if Larius Giotto Water Pump equipment does not suck the product?
- L
  llloydAug 19, 2025
  If your Larius Water Pump equipment isn't sucking the product, you can try the following: clean or replace the filter. If that doesn't work, replace the filter with a larger-mesh filter (or remove the filter if using very dense products). Also, check the suction pipe and press the manual unlocking device.
E
Elizabeth HolmesAug 25, 2025
What to do if Larius Giotto Water Pump pressure is normal but the product is not atomized?
- J
  Jared HarrisAug 26, 2025
  If the pressure of your Larius Water Pump is normal, but the product isn't atomizing, try cleaning or replacing the nozzle. You might also need to dilute the product or replace the filter with a larger-mesh filter.
J
Jessica Alexander MDAug 29, 2025
What to do if Larius Giotto Water Pump trigger releasing but equipment does not stop?
- B
  Brandon AlvarezAug 29, 2025
  If, when releasing the trigger of the gun, your Larius Water Pump equipment doesn't stop (the motor runs slowly and the piston rod moves up and down), replace the gaskets. If that doesn't resolve the issue, disassemble the pumping group and clean it. Also, verify and replace the pressure transmitter if necessary.
J
jjohnsonSep 3, 2025
What to do if Larius Water Pump pressure lowers considerably when pressing the trigger?
- C
  Christopher MunozSep 3, 2025
  If the pressure of your Larius Water Pump lowers considerably when pressing the trigger, replace the nozzle with a smaller one, dilute the product if possible, or replace the filter with a larger-mesh filter.