LAS 10318 - Withdrawal from Use; Maintenance; Contact Information

5
4.2 WITHDRAWAL FROM USE
The tensioning strap may no longer be used in the event of:
• Thread breaks and cuts, especially when caused by sharp edges
• Missing or no longer legible labelling
• Damage to the connection
• Damage or deformation due to the eects of heat
• Damages caused by aggressive substances
5. OPERATING INSTRUCTIONS
If these instructions are not observed, the result may be personal injury, damages to the vehicle or the load. Never load the strap in excess of the
permitted lashing force specied on the label.
• These straps are not suitable for lifting and carrying loads.
• Permitted lashing force: 250 daN.
• Do not tension the strap over sharp corners or edges.
• Lashing straps may not be twisted and the full width must make contact.
• No loads may be placed on top of the tensioning strap.
• The strap may not be positioned up against a hot surface.
• The tensioning belts may only be used in the following temperature ranges:
• Polypropylene (PP): -40°C to +80°C
• Polyamid (PA): -40°C to +100°C
• Polyester (PES): -40°C to +120°C
• When using polyamide of polyester tensioning straps, contaminations may be removed using ordinary solvents. The tensioning strap must be
allowed to dry fully. When using ordinary solvents, the applicable regulations are to be observed (e.g. data sheet for chlorinated hydrocarbon
ZH 1/194)
Wrap the strap around the objects. Make sure that the strap is not twisted. To close the strap, push the lever on the top of the lock down and guide
the loose end of the strap, from below, through the lock. Then release the lever. Tension the strap by holding the part with the clamping lock in one
hand and use the other hand to pull the loose section in the opposite direction through the lock.
Release the tensioning strap by pushing down on the lever and holding. Pull the loose end out of the lock.
5.1 ATTACHING THE TENSIONING STRAPS
These tensioning straps may only be used to wrap or bundle objects. They are not suitable as tie-downs for a load since they are only
tted with a clamping lock.
6. STORAGE AND MAINTENANCE
6.1 STORAGE
• Only store the straps in dry, lightly heated spaces.
• Protect from major sunlight.
• Do not dry or store the strap in the vicinity of re, radiators, heating pipes or other locations with extreme temperatures.
• Never store with chemicals.
6.2 MAINTENANCE
Maintenance work may only be carried out by the manufacturer or persons named by the manufacturer.
7. NOTES REGARDING ENVIRONMENTAL PROTECTION
Please dispose of the tensioning straps via the recycling bin or the public/municipal collection points.
The materials are recyclable. You make an important contribution to protecting our environment by recycling, material utilisation or other forms of
reusing waste equipment!
8. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com