CYCLE STOP OR END
To interrupt the appliance operation or the washing cycle, rotate G knob (washing cycles)
to N position (cycle end).
To stop the appliance, rotate D knob (power supply and water load) to 0 position.
W
ASHING DIFFICULTIES
Any stains, water drops, etc. stil present after the washing cycle could be caused by:
- Improper placement of tableware in the basket.
- Washing water too dirty.
- Improper rinsing water pressure.
- Improper washing or rinsing temperature.
- Rinsing water too hard.
- Too much or too little detergent.
- Unsuitable quantity of rinse aid.
- Obstructed nozzles or blocked washing/rinsing arms.
MANUALE DI INSTALLAZIONE, USO E MANUTENZIONE
INSTALLATION, USE AND MAINTENANCE MANUAL
21
To Next Page
Loading...
