LaserLine 670T - 10 - PROGRAMMING OF NEW ELECTRONIC KEY; 11 - 670 T TEST APPROVAL NUMBER

pag. 10
ENGLISH
ΠWith the alarm disarmed;
• Open bonnet;
Ž Turn the ignition key ON and OFF four times within four seconds, making sure that on
the fourth cycle the ignition is left in the ON position;
• The alarm will indicate the starting of the electronic procedure by, 3 acoustic signals and
3 flashes of the status led.;
• Insert each electronic key to be learnt to the alarm into the receptacle socket (LED will
flash once for each key learnt);
‘ Turn OFF the ignition; procedure completion will be indicated by 3 acoustic signals and
3 flashes of the receptacle LED.
’ Close bonnet.
Ø You can program a maximum of 4 electronic keys.
Ø Electronic keys not programmed during the last self-learning session will be automati-
cally cancelled from the alarm memory.
KEY * Optional. ** Vehicle dependent.
10 - PROGRAMMING OF NEW ELECTRONIC KEY
The procedure allows you to program new electronic keys.
To carry out the procedure, the bonnet switch must be fitted. Note: Not all installations
require the bonnet switch to be fitted, if this is the case please contact your original installer.
Then do the following:
670T - MIRRC Reference Number: Category 2 - 1 TU2-1426/1207
670T - MIRRC Reference Number: Category L2 - 1 TUL1-151/1207
11 - 670T TEST APPROVAL NUMBER
ISUT670T NEW.p6519/12/2011, 16.0610