LaserLiner GasCheck - Gas Cylinder Handling; Cylinder Preparation and Safety; Setup and Measurement Guidance; Battery Installation

GasCheck
07
.ODMSGDA@SSDQXBNLO@QSLDMSNM
the housing‘s rear side and insert
@5A@SSDQX"NQQDBSONK@QHSXLTRS
be observed.
1
Insert battery
3GDCDUHBDHRQD@CXENQTRDHLLDCH@SDKXNMBDSGDA@SSDQHDR
G@UDADDMHMRDQSDC(SCNDRMNSG@UD@RDO@Q@SD.-.%%
RVHSBG@MCHRSGDQDENQD@KV@XR@BSHUD
!
Notes on measurement
m2SDDKF@RBXKHMCDQR@QDMNQL@KKXÖKKDCTOSNCDODMCHMFNM
SGDOQNO@MDATS@MDLHWQ@SHN@MCSGDSDLODQ@STQD
m3GDLD@RTQHMFCDUHBDHRMNSRTHS@AKDENQTRDNMOK@RSHBF@RANSSKDR
m6HSGSGDDWBDOSHNMNEJF@MCJFRSDDK+/&BXKHMCDQR
SGDLD@RTQHMFCDUHBDHRRTHS@AKDNMKXSN@KHLHSDCDWSDMSENQ
LDS@KF@RBXKHMCDQR
m3GDLD@RTQDLDMSB@MAD@CUDQRDKX@EEDBSDCAXCHQSNMSGD
LD@RTQHMFGD@C@MCF@RBXKHMCDQ3GDLD@RTQHMFRTQE@BDRRGNTKC
SGDQDENQDADBKD@MDCVHSG@C@LOBKNSG
m/NRRHAKDHM×TDMBHMFE@BSNQRNMF@RBXKHMCDQRHMBKTCD
 1TRS@KRNHMUHRHAKD@QD@RNMSGDHMRHCD
 4MDUDMDWBDRRHUDKXSGHBJBN@SHMFNMSGDNTSDQV@KK
 (BDATHKCTONMSGDRTQE@BD
 #DMSDCNQRBQ@SBGDRRTQE@BDR
 1@CHHNETOODQ@MCKNVDQDMCRNEF@RBXKHMCDQRSNNRL@KK
To avoid these factors, the measurement should be carried out at
RDUDQ@KONHMSRHMSGDBKD@MDCBDMSQ@K@QD@NESGDF@RBXKHMCDQ
m3N@UNHCRKNOHMFKHPTHCKDUDKRSGDF@RBXKHMCDQRGNTKCAD@RTOQHFGS
@RONRRHAKDCTQHMFSGDLD@RTQDLDMS
– It is recommended to start the measurement from the bottom in
NQCDQSNCDSDQLHMDSGDLHMHLTLKDUDK@RE@RS@RONRRHAKD
m3GDDW@BSKDUDKHR@SSGDONHMSADSVDDMSGDRHFM@KR`&@Rj
and „No Gas“.
m,D@RTQDLDMSHRMNSONRRHAKDNMVDKCDCRD@LR
EN
Information on gas cylinders
– The measuring surface and the surface to be measured of
SGDF@RBXKHMCDQLTRSADEQDDNECHQSRSHBJDQR@MCQTRS
m.ARDQUDSGDR@EDSXQDFTK@SHNMRENQG@MCKHMFOQNO@MDATS@MD
F@RBXKHMCDQR
m3GDLD@RTQDLDMSHRMNS@RTARSHSTSDENQBNQQDBSQDRHCT@KF@RCHRONR@K