LaserLiner MoistureFinder - Function; Application

06
DRY
WET
green
yellow
red
1
6LR61 9V
2
MoistureFinder
DRY
WET
1.
2.
3.
ON/OFF HOLD
3 sec
MoistureFinder
DRY
WET
MODE HOLD
MoistureFinder
DRY
WET
MODE HOLD
MoistureFinder
DRY
WET
MODE HOLD
32
1
6
7
5
4
8
GB
Automatic switch-off
after 2 minutes.
Function / application
This material moisture measuring device operates on the impe-
dance measuring principle. Moisture-dependent permittivity of
the material is measured between 2 conductive rubber contacts
on the underside of the device and this measured value is
recalculated internally into % of material moisture based on
the material-dependent characteristic. The intended purpose
of the device is the non-destructive assessment of moisture
content in wood, screed and plaster.
ON/OFF
Material setup /
switchover
Hold current
measurement
1
2
3
Selected material
characteristic
Battery charge
Present measurement
is retained
Measured value in %
of relative material
moisture
4
5
6
7
8
Read the operating instructions and the enclosed bro-
chure „Guarantee and additional notices“ completely.
Follow the instructions they contain. Safely keep these
documents for future reference.
!
Wet/dry
LED display
12-position LED:
0…4 LEDs
green = dry
5…7 LEDs
yellow = moist
8…12 LEDs
red = wet