LaserLiner RollPilot S6 - Page 8

08
3
+ +R R
4
+R
To measure from wall to spot
1. Position the device with the rear of
the measuring wheel against the
wall.
2. Move the measuring wheel straight
to the marked spot.
3. Read off the measured value and
add the radius of the wheel.
Measurement
Measurement
To achieve accurate measurement results, the guide bar must be held
at the same angle during the entire measurement. A vertical position
is recommended.
!
To measure from wall to wall
1. Position the device with the rear of
the measuring wheel against the
wall.
2. Move the measuring wheel straight
to the other wall.
3. Read off the measured value and
add the diameter of the wheel.
EN
2
Fold for carrying
Manual_RollPilot_S6_Rev20W13.indd 8 01.04.20 13:38