SmartCross-Laser
07
1
+
+
–
–
GB
Read the operating instructions and the enclosed bro-
chure „Guarantee and additional notices“ completely.
Follow the instructions they contain. This document
must be kept in a safe place and if the laser device is
passed on, this document must be passed on with it.
!
The automatic cross-line laser for aligning tiles, wall
studding, windows, doors etc.
General safety instructions
– Attention: Do not look into the direct or reected beam.
– The laser may not get into the hands of children!
– Do not point the laser beam towards persons.
– If a person‘s eyes are exposed to class 2 laser radiation, they
should shut their eyes and immediately move away from the
beam.
– Do not expose the device to mechanical stress, extreme
temperatures, moisture or signicant vibration.
– The device must only be used in accordance with its intended
purpose and within the scope of the specications. Modi-
cations or changes to the device are not permitted, this will
otherwise invalidate the approval and safety specications.
Laser radiation!
Do not stare into the beam!
Class 2 laser
< 1 mW · 650 nm
EN 60825-1:2014
Always turn off all lasers and latch the pendulum in place
before transporting, ON/OFF switch in its „OFF“ position!
!
Inserting batteries
Open the battery compart-
ment and insert batteries
(2 x type AA) according to
the symbols. Be sure to pay
attention to polarity.
To Next Page
Loading...
