Need help?Do you have a question about the LaserPro Spirit SI and is the answer not in the manual?
Details the importance and location of the machine's serial number for record-keeping and support.
Outlines essential safety guidelines for operating the laser machine, emphasizing supervision and unattended operation.
Details the various mechanical components of the laser machine, including assemblies and modules.
Details the power supply configurations and wiring diagrams for different machine models.
Explains the electrical system, including the mainboard diagram and specific module details.
Covers the laser system, including types of tubes, power measurement, and beam alignment.
Explains the procedure for upgrading the machine's firmware using the uploader.exe utility.
Details how to access the hidden diagnostics menu and lists 11 diagnostic tests available.
Recommends cleaning optical lenses weekly or as needed using specific consumables.
Provides step-by-step instructions for cleaning the optical mirrors using cleaning paper and solution.
Details the process of removing and cleaning the focusing lens from the pen carriage.
Explains how to prevent X and Y rails from corrosion using NSK, PS2 grease.
Provides instructions and tips for changing the X rollers, including their lifespan and orientation.
Details the steps for removing and exchanging the X-axis assembly, including disconnecting cables and removing bolts.
Explains how to detach the X-rail and remove screws to change the Y roller holders.
Lists common error messages, their meanings, and recommended troubleshooting steps.
Explains how to identify problems by observing the status of LEDs on the mainboard.
Explains how to set the tickle pulse for Synrad laser sources to maintain readiness for firing.
To Next Page
General
