To Next PageTo Next Page
Need help?Do you have a question about the Laserworld FX Series and is the answer not in the manual?
General| Laser Class | 3B |
|---|---|
| Laser Sources | Diode |
| Housing Material | Aluminum |
| Modulation | Analog |
| Colors | Red, Green, Blue |
| Scan Speed | 30kpps |
| Beam Divergence | <2 mrad |
| Control Modes | DMX, Sound-to-Light |
| Power Supply | AC 100V - 240V, 50/60Hz |
| Operating Temperature | 10°C - 40°C |
| Wavelength | Red: 650nm, Green: 532nm, Blue: 447nm |
| Dimensions | Varies by model |
| Weight | Varies by model |
Ensure correct voltage and avoid connecting to mains during installation. Follow country-specific safety regulations.
Ensure maximum permissible exposure limits are not exceeded and install with minimum wall clearance.
Use safety cords, avoid immediate operation after temperature changes, and ensure sufficient ventilation.
Service by qualified engineer only. Disconnect power, use non-reflecting tools, and wear protective clothing.
Avoid moisture, heat, quick on/off switching, and shocks. Ensure ventilation and check temperature.
Warranty is void if labels are tampered with, or damage results from improper handling or neglecting instructions.
Connect device to mains with correct voltage. Ensure safe positioning during installation.
Navigate and select operation modes using Mode, Up, Down, and Enter buttons for menu and value changes.
Details LED display modes (R1, G1, B1, etc.) and their functions, including auto and DMX modes.
