35
transmission to
cutting head
Burnt V-belts Replacement
Worn (extended) V-
belts
Replacement
Insufficient
cutting head
power
Damaged blades Replacement
Opposite
blades
should be
replaced
always
together
Blunt or worn blades Replace or regrind
blades
Wire control out of
tune
Adjustment
service
Note: The note "SERVICE" in the "Remedy" column means that this operation
should be done by an authorised service only.
Waste Disposal
Waste DisposalWaste Disposal
Waste Disposal
Any waste materials resulting from the machine operation should be disposed in
accordance with laws and regulations valid in the given country.
Protect nature and water resources against used oil, lubricants and filter elements.
Any parts of the machine should be disposed in accordance with laws and
regulations valid in the given country.
We recommend proceeding as follows:
1. Remove all reusable parts, clean them, conserve and store for further usage.
2. Remove old lubricants and used-up oil, remove all plastic and rubber parts.
These parts should be disposed in accordance with laws and regulations valid
in the given country.
3. Remove all parts made of non-ferrous metals (bushings etc.). Remaining parts
of the machine, incl. non-ferrous metal parts, should be delivered to an
authorised waste collection point.
Recommended disposal of packages:
Wood - secondary waste recovery, burning
To Next Page